1968 Dodge Coronet Recalls

---

NHTSA Campaign Number: 67V073000
Manufacturer: Chrysler (FCA US LLC)
Date of Owner Notification: September 6th, 1967

Recall Notes:
POSSIBLE MISROUTING OF THE INSTRUMENT PANEL WIRING HARNESS AND/OR THE OMISSION OF A CRITICAL CLIP MAY ALLOW CONTACT WITH THE WINDSHIELD WIPER LINKAGE.OPERATION OF THE WINDSHIELD WIPERS COULD THEN RESULT IN CHAFING OF THE WIRING INSULATION WHICH COULD CAUSE A MALFUNCTION OF ANY ONE OF A NUMBER OF ELECTRICAL COMPONENTS OR THE COMPLETE ELECTRICAL SYSTEM.(INSPECT, REROUTE HARNESS, AND INSTALL CLIP AS NECES- SARY.)

---

NHTSA Campaign Number: 67V074000
Manufacturer: Chrysler (FCA US LLC)
Date of Owner Notification: September 6th, 1967

Recall Notes:
POSSIBLE INTERFERENCE BETWEEN THE POWER STEERING PRESSURE HOSE AND THE PUMP PULLEY OR BATTERY TRAY.THIS COULD RESULT IN CHAFING OF THE HOSE, LOSS OF POWER STEERING FLUID, AND MAY RENDER THE POWER STEERING INOPERATIVE.(REPLACE POWER STEERING PRESSURE HOSE ASSEMBLY.)

---

NHTSA Campaign Number: 67V103000
Manufacturer: Chrysler (FCA US LLC)
Date of Owner Notification: October 31st, 1967

Recall Notes:
POSSIBILITY THAT VEHICLES WERE ASSEMBLED WITHOUT REAR SHELF PANEL REINFORCEMENT PLATES FOR THE REAR SEAT SHOULDER BELTS.DURING SEVERE IMPACT, THIS PANEL COULD FAIL AT LESS THAN DESIGN IMPACT SPECIFICATIONS.(INSPECT AND INSTALL REINFORCEMENT PLATES AS REQUIRED.)

---

NHTSA Campaign Number: 67V104000
Manufacturer: Chrysler (FCA US LLC)
Date of Owner Notification: October 31st, 1967

Recall Notes:
POSSIBLE THAT VEHICLES WERE ASSEMBLED WITH AN INCORRECT POWER STEERING PRESSURE HOSE.THIS COULD RESULT IN PREMATURE FAILURE OF THE HOSE.A FAILURE OF THIS TYPE WOULD RESULT IN THE LOSS OF POWER STEERING ASSIST, WITHOUT WHICH GREATER MANUAL EFFORT IS REQUIRED TO MAINTAIN DIRECTIONAL CONTROL.(REPLACE THE SUBJECT HOSE.)