1995 International Harvester 8200 Recalls

---

NHTSA Campaign Number: 95E009002
Manufacturer: INTERNATIONAL TRUCK & ENGINE CORPORATION
Manufactured Begin Date: March 1st, 1995
Manufactured End Date: March 1st, 1995

Defect Summary:
DURING ASSEMBLY, THE TIE ROD END NUTS WERE NOT PROPERLY TORQUED. EXTREMELY LOW TORQUE CAN ALLOW MOVEMENT BEWEEN THE BALL STUD AND THE TIE ROD ARM CAUSING DAMAGE.

Consequence Summary:
THIS CONDITION CAN AFFECT THE DRIVER'S ABILITY TOSTEER THE VEHICLE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Corrective Summary:
DEALERS WILL CHECK THE TORQUE ON THE BALL STUDS OF THE SUSPECT AXLES AND BRING THE TORQUE UP TO ROCKWELL'S SPECIFICATIONS.

Recall Notes:
SYSTEM: STEERING; LINKAGES; TIE ROD; END.VEHICLE DESCRIPTION: MEDIUM AND HEAVY DUTY TRUCKS EQUIPPED WITH ROCKWELL NON-DRIVING FRONT AXLES, MODELS FF-942, FF-961 OR FL-941.NOTE: IF YOUR VEHICLE IS PRESENTED TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND THE REMEDY IS NOT PROVIDED FREE OF CHARGE WITHIN A REASONABLE TIME, PLEASE CONTACT NAVISTAR AT 1-800-448-7825. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.

---

NHTSA Campaign Number: 95V144000
Manufacturer: INTERNATIONAL TRUCK & ENGINE CORPORATION
Manufactured Begin Date: April 1st, 1995
Manufactured End Date: May 1st, 1995
Date of Owner Notification: August 15th, 1995

Defect Summary:
THESE VEHICLES WERE BUILT WITH AN IMPROPERLY PLUMBED BRAKE SYSTEM WHICH AFFECTS THE BRAKING ON THE REAR AXLE WHEN RUNNING EITHER BOBTAIL OR PULLING A TRAILER.

Consequence Summary:
THIS CONDITION CAN AFFECT THE STOPPING ABILITY OF THE VEHICLE BECAUSE THE FRONT STEER AXLE BRAKES AND TRAILER'S BRAKES WOULD BE DOING MOST OF THE BRAKING. INCREASED STOPPING DISTANCES WOULD BE REQUIRED CAUSING ACCELERATED WEAR ON THE STEER AXLE AND THE TRAILER BRAKES.

Corrective Summary:
NAVISTAR DEALERS WILL INSPECT VEHICLES AND REPAIR BY INSTALLING BRAKE LINES AND FITTINGS AS REQUIRED.

Recall Notes:
SYSTEM: BRAKES; HYDRAULIC; LINES; NONMETALLIC.VEHICLE DESCRIPTION: TRUCK TRACTORS BUILT WITH PROPORTIONAL BRAKES.NOTE: OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME, SHOULD CONTACT NAVISTAR AT 1-800-448-7825. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.

---

NHTSA Campaign Number: 94V196000
Manufacturer: INTERNATIONAL TRUCK & ENGINE CORPORATION
Manufactured Begin Date: January 1st, 1994
Manufactured End Date: June 1st, 1994
Date of Owner Notification: October 17th, 1994

Defect Summary:
THE BASE OF THE ELECTRONIC ACCELERATOR PEDAL IS MADE OF DIE CAST ALUMINUM. THE BASE MOUNTS DIRECTLY TO THE CAB FIREWALL. THE CAB FIREWALL IS NOT RIGID ENOUGH OR FLAT ENOUGH AT THE MOUNTING SURFACE, CAUSING STRESS ON THE ACCELERATOR BASE THAT WILL CAUSE THE MOUNTING PADS ON THE BASE OF THE PEDAL ASSEMBLY TO FAIL AND TOTALLY SEPARATE FROM THE FIREWALL.

Consequence Summary:
THIS CAN CAUSE LOSS OF SPEED CONTROL, DRIVER DISTRACTION, AND RESULT IN AN ACCIDENT.

Corrective Summary:
DEALERS WILL INSPECT THE ACCELERATOR PEDAL ASSEMBLY AND INSTALL A PLATE BETWEEN THE ACCELERATOR MOUNTING BASE AND THE FIREWALL ON THOSE UNITS WHERE THE BASE IS NOT BROKEN AND HAS NO VISIBLE SIGNS OF A CRACK. IF THE BASE IS BROKEN OR CRACKED, THE ACCELERATOR ASSEMBLY WILL BE REPLACED WITH A NEW REDESIGNED ACCELERATOR PEDAL ASSEMBLY.

Recall Notes:
SYSTEM: FUEL; THROTTLE LINKAGES AND CONTROL; PEDAL.VEHICLE DESCRIPTION: TRANSIT BUSES, SCHOOL BUSES, HEAVY AND MEDIUM DUTY TRUCKS.NOTE: IF THE VEHICLE IS PRESENTED TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND THE REMEDY IS NOT PROVIDED FREE OF CHARGE WITHIN A REASONABLE TIME OR THE REMEDY DOES NOT CORRECT THE DEFECT, PLEASE CONTACT NAVISTAR AT 1-800-448-7825. ALSO, CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.