1979 Ford Mustang Recalls

---

NHTSA Campaign Number: 08E019000
Manufacturer: FORD MOTOR COMPANY
Date of Owner Notification: March 19th, 2008

Defect Summary:
INTERCONTINENTAL AUTO PARTS IS RECALLING 1,937 FUEL FILTERS, P/NOS ALG 44/1 AND PUROLATOR F10024, SHIPPED BETWEEN JANUARY 14 AND FEBRUARY 13, 2008, SOLD FOR USE ON THE VEHICLES LISTED ABOVE. THE FILTER'S OUTLET CAP MAY NOT BE SECURELY CRIMPED TO THE HOUSING. THIS COULD RESULT IN A SEPARATION OF FILTER'S OUTLET CAP FROM THE HOUSING.

Consequence Summary:
IF THIS CONDITION OCCURS WHILE ATTEMPTING TO START THE VEHICLE, A NO START CONDITION MAY RESULT AND FUEL MAY BE PUMPED ONTO THE GROUND. IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION, THE ENGINE MAY STOP DUE TO INADEQUATE FUEL SUPPLY. IF AN IGNITION SOURCE WERE PRESENT, FUEL LEAKAGE MAY RESULT IN A FIRE.

Corrective Summary:
INTERCONTINENTAL WILL REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING MARCH 2008. OWNERS MAY CONTACT INTERCONTINENTAL AT 800-451-2593.

Recall Notes:
THIS RECALL ONLY PERTAINS TO INTERCONTINENTAL AFTERMARKET FUEL FILTERS AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON VEHICLES MANUFACTURED BY THE FORD MOTOR COMPANY.CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

---

NHTSA Campaign Number: 07E064000
Manufacturer: FORD MOTOR COMPANY
Date of Owner Notification: October 15th, 2007

Defect Summary:
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

Consequence Summary:
A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.

Corrective Summary:
FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.

Recall Notes:
THIS RECALL ONLY PERTAINS TO AFTERMARKET CARTER, NAPA, ACCUFLOW, TRU FLOW, PARTS MASTER, AND PARTS DEPOT BRAND FUEL PUMPS AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON THE LISTED MOTOR VEHICLES.CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

---

NHTSA Campaign Number: 79V053000
Manufacturer: FORD MOTOR COMPANY
Manufactured Begin Date: December 1st, 1978
Manufactured End Date: January 1st, 1979
Date of Owner Notification: March 28th, 1979

Defect Summary:
AN INCORRECT STEERING GEAR FLANGE MAY HAVE BEEN INSTALLED, WHICH MAY SLIP AND CAUSE EVENTUAL LOSS OF STEERING CONTROL.

Corrective Summary:
INSPECTION FOR AND REPLACEMENT OF INCORRECT STEERING GEAR FLANGES WILL BE DONE AT NO COST TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH POWER STEERING.SYSTEM: STEERING; GEAR FLANGE.CONSEQUENCES OF DEFECT: LOSS OF STEERING CONTROL MAY RESULT IN VEHICLEACCIDENT.NOTE: AN UNUSUAL RATCHETING NOISE OR MISPOSITIONING OF THE STEERING WHEEL MAYINDICATE SLIPPAGE OF THE STEERING GEAR FLANGE. DO NOT DRIVE SUSPECT VEHICLESUNTIL INSPECTION AND REPAIRS ARE COMPLETED.

---

NHTSA Campaign Number: 78V211000
Manufacturer: FORD MOTOR COMPANY
Manufactured Begin Date: August 1st, 1978
Manufactured End Date: September 1st, 1978
Date of Owner Notification: October 4th, 1978

Defect Summary:
THE INVOLVED VEHICLES ARE EQUIPPED WITH FLEXIBLE COOLING FAN BLADES THAT MAY CRACK WHEN SUBJECTED TO HIGH ENGINE SPEED OPERATING CONDITIONS. FAN BLADE CRACKING CAN LEAD TO FRAGMENTS SEPARATING FROM THE FAN.

Corrective Summary:
THE DEALER WILL REPLACE THE EXISTING COOLING FAN AT NO COST TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH 5.0 LITER ENGINES.SYSTEM: ENGINE COOLING; ENGINE COOLING FAN.CONSEQUENCES OF DEFECT: IF THE HOOD IS OPEN AND THE ENGINE IS RUNNING, THEFRAGMENTS COULD FLY FREE, DAMAGING OTHER ENGINE COMPONENTS AND CAUSING SERIOUSINJURY TO PERSONS IN THE AREA.NOTE: THE ENGINE SHOULD NOT BE OPERATED WITH THE HOOD OPEN UNTIL THE PROBLEMHAS BEEN CORRECTED.

---

NHTSA Campaign Number: 79V117000
Manufacturer: FORD MOTOR COMPANY
Manufactured Begin Date: February 1st, 1979
Manufactured End Date: March 1st, 1979
Date of Owner Notification: June 18th, 1979

Defect Summary:
THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Corrective Summary:
DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES.SYSTEM: SERVICE BRAKES; HYDRAULIC LINKAGE, PEDAL.CONSEQUENCES OF DEFECT: DISENGAGEMENT OF THE BRAKE PEDAL WOULD RESULT IN TOTALLOSS OF SERVICE BRAKES, WHICH COULD LEAD TO LOSS OF VEHICLE CONTROL AND ANACCIDENT.NOTE: THE PARKING BRAKE WILL REMAIN OPERATIONAL EVEN IF SERVICE BRAKES ARELOST.

---

NHTSA Campaign Number: 78V186000
Manufacturer: FORD MOTOR COMPANY
Date of Owner Notification: June 30th, 1979

Defect Summary:
THE TILT STEERING COLUMNS ON THE INVOLVED VEHICLES CONTAIN IN-PROCESS TEMPORARY ALIGNMENT PINS RATHER THAN THE PERMANENT PRESS-FIT PIVOT PINS. THE TEMPORARY PINS ARE SLIGHTLY UNDERSIZED AND COULD SEPARATE FROM THE STEERING COLUMN DURING VEHICLE OPERATION. THIS CAN CAUSE STEERING WHEEL LOCKUP.

Corrective Summary:
THE DEALER WILL INSTALL A PERMANENT PIVOT PIN IN THE STEERING COLUMN WITHOUT CHARGE TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES.SYSTEM: STEERING; STEERING COLUMN, TILT.CONSEQUENCES OF DEFECT: STEERING WHEEL LOCKUP CAN CAUSE LOSS OF VEHICLE CONTROLAND AN ACCIDENT.

---

NHTSA Campaign Number: 79V087000
Manufacturer: FORD MOTOR COMPANY
Manufactured Begin Date: March 1st, 1979
Manufactured End Date: March 1st, 1979
Date of Owner Notification: March 31st, 1979

Defect Summary:
WITH THE ENGINE OPERATING AT HIGH SPEED, THE PLASTIC ENGINE FAN FINGER GUARDS MAY CONTACT THE ENGINE FAN AND BREAKAGE OF THE GUARD MAY OCCUR. THIS COULD CAUSE FRAGMENTS OF THE FINGER GUARD TO SCATTER.

Corrective Summary:
TWO GUARD SUPPORTS AND TWO ADDITIONAL FASTENERS WILL BE INSTALLED. IF THE FAN GUARD HAS BEEN DAMAGED, THE GUARD AND FAN WILL BE REPLACED AT NO COST TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH 200 CID ENGINES.SYSTEM: ENGINE & ENGINE COOLING; FAN.CONSEQUENCES OF DEFECT: IF THE HOOD IS OPEN DURING ENGINE OPERATION, PERSONS INTHE VICINITY MAY BE INJURED IN THE EVENT OF FAN FAILURE.NOTE: HOOD SHOULD NOT BE LEFT OPEN DURING ENGINE OPERATION UNTIL CORRECTIONSHAVE BEEN COMPLETED.