1984 Ford Bronco Ii Recalls

---

NHTSA Campaign Number: 07E064000
Manufacturer: FORD MOTOR COMPANY
Date of Owner Notification: October 15th, 2007

Defect Summary:
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

Consequence Summary:
A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.

Corrective Summary:
FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.

Recall Notes:
THIS RECALL ONLY PERTAINS TO AFTERMARKET CARTER, NAPA, ACCUFLOW, TRU FLOW, PARTS MASTER, AND PARTS DEPOT BRAND FUEL PUMPS AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON THE LISTED MOTOR VEHICLES.CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

---

NHTSA Campaign Number: 84V023000
Manufacturer: FORD MOTOR COMPANY
Manufactured Begin Date: January 1st, 1984
Manufactured End Date: February 1st, 1984
Date of Owner Notification: February 22nd, 1984

Defect Summary:
COMPONENTS IN THE LOCKING HUBS WERE IMPROPERLY HEAT-TREATED AND MAY CRACK OR FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. THE BROKEN COMPONENT ON THE LEFT FRONT WHEEL MAY BECOME JAMMED AGAINST THE NUT.

Corrective Summary:
CAM ASSEMBLIES IN FRONT WHEEL AUTOMATIC LOCKING HUBS WILL BE REPLACED.

Recall Notes:
VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH FRONT AUTOMATIC LOCKING HUBS.SYSTEM: POWER TRAIN; AXLE HUBS, LOCKING.CONSEQUENCES OF DEFECT: THIS COULD CAUSE THE NUT TO COME OFF AND RESULT IN LOSSOF THE LEFT FRONT WHEEL, CAUSING LOSS OF VEHICLE CONTROL AND AN ACCIDENT.

---

NHTSA Campaign Number: 83V134000
Manufacturer: FORD MOTOR COMPANY
Manufactured Begin Date: August 1st, 1983
Manufactured End Date: December 1st, 1983
Date of Owner Notification: December 22nd, 1983

Defect Summary:
THE BOLTS THAT ATTACH THE D-SHAPED RING FOR THE SHOULDER BELT ARE INADEQUATELY SUPPORTED BY THE MATERIAL IN WHICH THEY ARE MOUNTED. THE ATTACHMENT DOES NOT COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".

Corrective Summary:
DEALERS WILL INSTALL NEW ATTACHING HARDWARE TO IMPROVE THE STRENGTH OF THE MOUNTING.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND LIGHT TRUCKS.SYSTEM: INTERIOR SYSTEMS; SEAT BELTS AND UPPER TORSO RESTRAINT ATTACHMENTS.CONSEQUENCES OF DEFECT: IN SEVERE COLLISIONS, THE SHOULDER BELT ATTACHMENTCOULD SEPARATE, INCREASING THE POSSIBILITY OF OCCUPANT INJURY.NOTE: MANUFACTURER ADVISES THAT SEAT BELTS SHOULD CONTINUE TO BE USED AT ALLTIMES, AS SUBSTANTIAL BENEFITS MAY STILL BE OBTAINED.