1982 Chevrolet G20 Recalls

---

NHTSA Campaign Number: 07E088000
Manufacturer: GENERAL MOTORS LLC
Date of Owner Notification: November 8th, 2007

Defect Summary:
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

Consequence Summary:
THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

Corrective Summary:
HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

Recall Notes:
CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

---

NHTSA Campaign Number: 90V137000
Manufacturer: GENERAL MOTORS LLC
Manufactured Begin Date: September 1st, 1978
Manufactured End Date: December 1st, 1984
Date of Owner Notification: August 23rd, 1990

Consequence Summary:
OCCUPANTS WOULD NOT BE ADEQUATELY PROTECTED IN EVENT OFAN ACCIDENT OR SUDDEN STOP.

Corrective Summary:
INSTALL PROPER MOUNTING HARDWARE AND SEAT BELTS.

Recall Notes:
NOTE: THIS RECALL WAS INITIALIZED BY MARK III INDUSTRIES.SYSTEM: SEAT BELTS, SEAT BELT ANCHORS, AND SEAT MOUNTING. DOM: SEPT. 1978 TOSEPT. 1984.DESCRIPTION ON DEFECT: IMPROPER MOUNTING HARDWARE AND IMPROPER SAFETY RESTRAINTSYSTEMS MAY HAVE BEEN INSTALLED IN THESE VEHICLES.

---

NHTSA Campaign Number: 83V045000
Manufacturer: GENERAL MOTORS LLC
Manufactured Begin Date: August 1st, 1981
Manufactured End Date: April 1st, 1982
Date of Owner Notification: May 3rd, 1983

Defect Summary:
THE LOCKING SCREW THAT RETAINS THE PINION SHAFT IN PLACE IN THE DIFFERENTIAL COULD COME LOOSE. THE PINION SHAFT TURNS THE GEARS INSIDE THE DIFFERENTIAL THAT ROTATE THE DRIVE AXLES AND REAR WHEELS. IF THE LOCKING SCREW COMES LOOSE, IT COULD DAMAGE OTHER COMPONENTS OR JAM IN THE GEARS. IF THE PINION SHAFT COMES LOOSE, THE REAR WHEELS MAY NO LONGER POWER THE VEHICLE.

Corrective Summary:
THE DEALER WILL REPLACE THE DIFFERENTIAL LOCK SCREW AT NO CHARGE.

Recall Notes:
VEHICLE DESCRIPTION: LIGHT TRUCKS EQUIPPED WITH EATON LOCKING DIFFERENTIAL.SYSTEM: POWER TRAIN; DIFFERENTIAL SHAFT LOCK SCREW.CONSEQUENCES OF DEFECT: IF THE FAILURE SHOULD OCCUR WHILE THE VEHICLE IS INMOTION, THE DRIVER MAY LOSE CONTROL OF THE VEHICLE AND AN ACCIDENT COULDRESULT.