1979 Chevrolet G20 Recalls

---

NHTSA Campaign Number: 07E088000
Manufacturer: GENERAL MOTORS LLC
Date of Owner Notification: November 8th, 2007

Defect Summary:
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

Consequence Summary:
THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

Corrective Summary:
HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

Recall Notes:
CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

---

NHTSA Campaign Number: 90V137000
Manufacturer: GENERAL MOTORS LLC
Manufactured Begin Date: September 1st, 1978
Manufactured End Date: December 1st, 1984
Date of Owner Notification: August 23rd, 1990

Consequence Summary:
OCCUPANTS WOULD NOT BE ADEQUATELY PROTECTED IN EVENT OFAN ACCIDENT OR SUDDEN STOP.

Corrective Summary:
INSTALL PROPER MOUNTING HARDWARE AND SEAT BELTS.

Recall Notes:
NOTE: THIS RECALL WAS INITIALIZED BY MARK III INDUSTRIES.SYSTEM: SEAT BELTS, SEAT BELT ANCHORS, AND SEAT MOUNTING. DOM: SEPT. 1978 TOSEPT. 1984.DESCRIPTION ON DEFECT: IMPROPER MOUNTING HARDWARE AND IMPROPER SAFETY RESTRAINTSYSTEMS MAY HAVE BEEN INSTALLED IN THESE VEHICLES.

---

NHTSA Campaign Number: 79V142000
Manufacturer: GENERAL MOTORS LLC
Manufactured Begin Date: December 1st, 1978
Manufactured End Date: January 1st, 1979

Defect Summary:
ON THE INVOLVED VEHICLES THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH WHICH IS OPERATED BY THE BRAKE PEDAL MAY HAVE BEEN ASSEMBLED WITH AN INCORRECT LUBRICANT ON THE ACTUATING PLUNGER. THIS CAN CAUSE THE REAR BRAKE STOPLIGHTS TO BECOME INOPERATIVE AND THE CRUISE CONTROL, IF ACTIVATED, TO STAY ELECTRICALLY ENGAGED.

Corrective Summary:
DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH AT NO COST TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES.SYSTEM: LIGHTING AND COMMUNICATIONS; SWITCH BUTTON RING, BRAKE LIGHTS.CONSEQUENCES OF DEFECT: WITH INOPERATIVE BRAKE LIGHTS, A VEHICLE APPROACHINGFROM THE REAR WOULD NOT BE AWARE THAT BRAKES WERE BEING APPLIED. ALSO, IF THECRUISE CONTROL FAILS TO AUTOMATICALLY DISENGAGE THROUGH BRAKE PEDAL OPERATION,VEHICLE MAY ACCELERATE WHEN THE BRAKE PEDAL IS RELEASED. EITHER CONDITION COULDRESULT IN LOSS OF VEHICLE CONTROL AND AN ACCIDENT.NOTE: OWNER IS ADVISED NOT TO ENGAGE THE CRUISE CONTROL UNTIL IT HAS BEENINSPECTED BY DEALER.