1979 Chevrolet Camaro Recalls

---

NHTSA Campaign Number: 07E088000
Manufacturer: GENERAL MOTORS LLC
Date of Owner Notification: November 8th, 2007

Defect Summary:
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

Consequence Summary:
THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

Corrective Summary:
HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

Recall Notes:
CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

---

NHTSA Campaign Number: 80V108000
Manufacturer: GENERAL MOTORS LLC
Manufactured Begin Date: August 1st, 1979
Manufactured End Date: February 1st, 1980
Date of Owner Notification: August 25th, 1980

Defect Summary:
ON CERTAIN VEHICLES, THE LOWER CONTROL ARM BALL JOINT TO STEERING KNUCKLE ATTACHING NUT MAY NOT HAVE BEEN TORQUED TO SPECIFICATIONS. THIS CONDITION COULD CAUSE THE NUT TO BACK OFF, RESULTING IN JOINT SEPARATION.

Corrective Summary:
THE DEALER WILL PERFORM A TORQUE CHECK OF THE ATTACHING NUT, AND, IF NECESSARY, TIGHTEN IT. IN SOME CASES AN INADEQUATE TORQUE LEVEL MAY HAVE CAUSED BALL STUD OR STEERING KNUCKLE DAMAGE; IF SO, THE AFFECTED COMPONENTS WILL BE REPLACED AT NO CHARGE TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES.SYSTEM: STEERING; LOWER CONTROL ARM BALL JOINT TO STEERING KNUCKLE ATTACHMENTNUT.CONSEQUENCES OF DEFECT: IF JOINT SEPARATION WERE TO OCCUR DRUING VEHICLEOPERATION, IT COULD AFFECT DIRECTIONAL CONTROL, WHICH COULD RESULT IN A VEHICLEACCIDENT WITHOUT PRIOR WARNING.

---

NHTSA Campaign Number: 79V142000
Manufacturer: GENERAL MOTORS LLC
Manufactured Begin Date: December 1st, 1978
Manufactured End Date: January 1st, 1979

Defect Summary:
ON THE INVOLVED VEHICLES THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH WHICH IS OPERATED BY THE BRAKE PEDAL MAY HAVE BEEN ASSEMBLED WITH AN INCORRECT LUBRICANT ON THE ACTUATING PLUNGER. THIS CAN CAUSE THE REAR BRAKE STOPLIGHTS TO BECOME INOPERATIVE AND THE CRUISE CONTROL, IF ACTIVATED, TO STAY ELECTRICALLY ENGAGED.

Corrective Summary:
DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH AT NO COST TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: PASSENGER VEHICLES.SYSTEM: LIGHTING AND COMMUNICATIONS; SWITCH BUTTON RING, BRAKE LIGHTS.CONSEQUENCES OF DEFECT: WITH INOPERATIVE BRAKE LIGHTS, A VEHICLE APPROACHINGFROM THE REAR WOULD NOT BE AWARE THAT BRAKES WERE BEING APPLIED. ALSO, IF THECRUISE CONTROL FAILS TO AUTOMATICALLY DISENGAGE THROUGH BRAKE PEDAL OPERATION,VEHICLE MAY ACCELERATE WHEN THE BRAKE PEDAL IS RELEASED. EITHER CONDITION COULDRESULT IN LOSS OF VEHICLE CONTROL AND AN ACCIDENT.NOTE: OWNER IS ADVISED NOT TO ENGAGE THE CRUISE CONTROL UNTIL IT HAS BEENINSPECTED BY DEALER.