1976 Chevrolet C20 Recalls

---

NHTSA Campaign Number: 07E088000
Manufacturer: GENERAL MOTORS LLC
Date of Owner Notification: November 8th, 2007

Defect Summary:
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

Consequence Summary:
THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

Corrective Summary:
HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

Recall Notes:
CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

---

NHTSA Campaign Number: 77V098000
Manufacturer: GENERAL MOTORS LLC
Manufactured Begin Date: August 1st, 1974
Manufactured End Date: August 1st, 1976
Date of Owner Notification: June 24th, 1977

Defect Summary:
THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE.

Corrective Summary:
DEALER WILL INSPECT AND, WHERE NECESSARY, WILL REPLACE THE BALL JOINTS WITHOUT CHARGE TO OWNER.

Recall Notes:
VEHICLE DESCRIPTION: LIGHT TRUCKS.SYSTEM: SUSPENSION; INDEPENDENT FRONT CONTROL ARM, LOWER.CONSEQUENCES OF DEFECT: IF SUSPENSION COLLAPSES WHILE VEHICLE IS IN MOTION,LOSS OF VEHICLE CONTROL AND AN ACCIDENT COULD OCCUR.

---

NHTSA Campaign Number: 77V178000
Manufacturer: GENERAL MOTORS LLC
Date of Owner Notification: November 7th, 1977

Defect Summary:
THE ACCELERATOR PEDAL ROD IN COMBINATION WITH THE PEDAL INSTALLED ON THE INVOLVED VEHICLES MAY CUT THROUGH THE FLOOR PAN RUBBER MAT OR CARPET INTO THE THICK RESILIENT INSULATION PAD UNDERNEATH DURING HEAVY OR REPEATED FULL THROTTLE APPLICATIONS. AS A RESULT, THE ACCELERATOR PEDAL ROD MAY CATCH IN THE MAT OR CARPET, PREVENTING THE THROTTLE FROM RETURNING TO IDLE WHEN THE DRIVER"S FOOT IS REMOVED FROM THE PEDAL.

Corrective Summary:
DEALER WILL INSTALL A NEW ACCELERATOR PEDAL AND RETAINER DESIGNED TO PREVENT THE ACCELERATOR PEDAL ROD FROM CUTTING THE RUBBER MAT OR CARPET. THIS WILL BE PERFORMED WITHOUT CHARGE.

Recall Notes:
VEHICLE DESCRIPTION: LIGHT TRUCKS.SYSTEM: THROTTLE LINKAGES AND CONTROL; ACCELERATOR PEDAL ROD.CONSEQUENCES OF DEFECT: IN THE EVENT THAT THE THROTTLE DOES NOT RETURN TO IDLE,THE VEHICLE WOULD NOT DECELERATE AS EXPECTED AND LOSS OF VEHICLE CONTROL AND ANACCIDENT COULD RESULT.